Siemens HydroRanger 200 HMI - Default Auxiliary Reading (2.12.7.); Display Delay (2.12.8.); Flow (2.13.); Transducer Selector (2.13.1.)

Parameter reference
8.6 Setup (2.)
HydroRanger 200 HMI
Operating Instructions, 06/2018, A5E36281317-AC
239
8.6.12.7
Default auxiliary reading (2.12.7.)
Determines the parameter that displays in the Auxiliary Reading after powering up the
device.
Index
Global
Options
*Totalizer
Level
Space
Distance
Volume
Flow
Head
Temperature
Rate
Fail-safe remaining
Confidence
Echo Strength
mA Output 1
mA Output 2
mA Input
8.6.12.8
Display delay (2.12.8.)
Adjusts the time before the next Point reading is displayed.
Index
Level
Values
Range: 0.5 ... 10
Preset: 1.5 seconds
Related
Sensor mode (2.1.3.) (Page 163)
Use this feature to adjust the delay before the display advances to the next Point reading.
Display scrolling is independent from transducer scanning.
8.6.13
Flow (2.13.)
The calculated flowrate in Maximum Flow units (2.13.4.3.) (Page 243).
8.6.13.1
Transducer selector (2.13.1.)
Sets the transducer index for all parameters applicable to this sub-menu. The parameters set
will only apply if Sensor Mode (2.1.3.) (Page 163) = Flow rate in open channel.