Siemens HydroRanger 200 HMI - Construction

Technical data
11.4 Programming
HydroRanger 200 HMI
Operating Instructions, 06/2018, A5E36281317-AC
297
11.4
Programming
Primary Local push buttons
Secondary
PC running SIMATIC PDM
11.5
Outputs
mA analog
• Single- or dual-point versions include two mA
outputs
• 0 ... 20 mA
• 4 ... 20 mA
2
• 750 ohm maximum
• Resolution of 0.1 %
• Isolated
Relays
1
• Six • 4-control
• 2- alarm control
• All relays rated 5A at 250 V AC, non-
inductive.
Control relays
4 Form A, NO relays (numbers 1, 2, 4, 5)
Alarm relay 2 Form C, NO, or NC relay (numbers 3, 6)
Communication
• RS-232 running Modbus RTU and ASCII via
RJ-11 connector
• RS-485 running Modbus RTU and ASCII via
terminal blocks
Optional
SmartLinx communication card compatible
1
All relays are certified only for use with equipment that fails in a state at or under the rated
maximums of the relays.
2
Device will output a high current reading upon applying and removing power.