Siemens HydroRanger 200 HMI - Error handling

Communications
C.38 Relay function codes (2.8.1.4. Relay function only)
HydroRanger 200 HMI
Operating Instructions, 06/2018, A5E36281317-AC
343
C.38
Relay function codes (2.8.1.4. Relay function only)
Please note that the device offers more function codes.
If a device parameter returns a relay function code, that message is converted to a number
and is then provided in the register. The numbers are shown in the following table:
Control
Relay function code
Number
Relay function (2.8.1.4.)
(Page 195)
General
OFF, relay not used
0
*OFF (Page 195)
Undesignated Level Alarm 1 Level (Page 195)
Lo-Lo Level Alarm
2
Level – LL (Page 195)
Low Level Alarm 3 Level – L (Page 195)
High Level Alarm
4
Level – H (Page 195)
Hi-Hi Level Alarm
5
Level – HH (Page 195)
In-bounds Alarm
6
In-bounds (Page 195)
Out-of-bounds Alarm 9 Out-of-bounds
(Page 195)
Rate of Level Change Alarm 12 Rate of Change
(Page 195)
Temperature Alarm 15 Temperature
(Page 195)
Loss of Echo (LOE) Alarm
20
LOE (Page 195)
Transducer Cable Fault
Alarm
16 Cable Fault (Page 195)
Flow
Totalizer
22
Totalizer (Page 195)
Flow Sampler 23 Flow Sampler
(Page 195)
Pump
Fixed Duty Assist 25 Fixed Duty Assist
(Page 195)
Fixed Duty Backup 26 Fixed Duty Backup
(Page 195)
Alternate Duty Assist 30 Alternate Duty Assist
(Page 195)
Alternate Duty Backup 31 Alternate Duty Backup
(Page 195)
Service Ratio Duty Assist 35 Service Ratio Duty
Assist (Page 195)
Service Ratio Duty Backup 36 Service Ratio Duty
Backup (Page 195)
First In First Out (FIFO) 40 First In First Out
(Page 195)
Control
Flush Value
65
Flush Valve (Page 195)
Communication 66 Communication
(Page 195)
See Relay function (2.8.1.4.) (Page 195)