Siemens HydroRanger 200 HMI - Maximum Volume (2.7.3.); Dimension a (2.7.4.)

Parameter reference
8.6 Setup (2.)
HydroRanger 200 HMI
188 Operating Instructions, 06/2018, A5E36281317-AC
8.6.7.3
Maximum volume (2.7.3.)
Enters the maximum volume of the vessel.
Index
Level
Values
Range: 0.000 ... 99999
Preset: 100.000
Alters
Decimal position (2.12.4.) (Page 237)
Related
• Empty (2.2.4.) (Page 170)
• Span (2.2.2.) (Page 169)
• Head (3.2.8.13) (Page 258)
Enter the vessel volume corresponding to Span (2.2.2.) (Page 169). For example, if your
maximum vessel volume is 8000 L, enter a value of 8000. For readings in volumetric units
(rather than percent), enter the equivalent vessel volume for Span (2.2.2.) (Page 169). Any
volume units can be chosen because volume is calculated from empty to maximum span,
and is scaled according to the Vessel Shape (2.7.2.) (Page 186) value.
Note
Make sure selected chosen units allow LCD volume display.
Examples:
•
If max. volume = 3650 m
3
, enter 3650
•
If max. volume = 267500 gallons, enter 267.5 (thousands of gallons)
8.6.7.4
Dimension A (2.7.4.)
Enters the height of the vessel bottom when the bottom is conical, parabolic, spherical, or flat
sloped. If the vessel is horizontal with parabolic ends, the depth of the end. For illustrations,
see Vessel shape (2.7.2.) (Page 186)
Dimension A as used in Vessel shape (2.7.2.) (Page 186).
Index
Level
Values
Range: 0.000 ... 99.000 m or equivalent, depending on Units (2.1.1.) (Page 162)
Preset: 0.000
Related
Vessel shape (2.7.2.) (Page 186)
Enter one of the following:
● Height of the tank bottom, if Vessel Shape (2.7.2.) (Page 186) = Conical Bottom,
Parabolic Bottom, Half Sphere Bottom, or Flat Sloped Bottom, or
● Length of one end section of the tank, if Vessel Shape (2.7.2.) (Page 186) = Parabolic
Ends, in Units (2.1.1.) (Page 162).