Siemens HydroRanger 200 HMI - Transducer Selector (2.1.4.); Transducer (2.1.5.)

Parameter reference
8.6 Setup (2.)
HydroRanger 200 HMI
164 Operating Instructions, 06/2018, A5E36281317-AC
8.6.1.4
Transducer selector (2.1.4.)
Sets the transducer index for all parameters applicable to this sub-menu. All parameter
values will then apply to the selected index.
To view or set a parameter for a different index, select it in this parameter
.
Options
*Transducer 1
Transducer 2
If Transducer 1 is selected, the Empty (2.2.4.) (Page 170) and Span (2.2.2.) (Page 169)
values viewed in that particular parameter apply only to Transducer 1. Any change to the
values will be applied to Transducer 1.
Note
To set or read
Empty (2.2.4.) (Page 170) and Span (2.2.2.) (Page 169
) for Transducer 2, the
selector parameter must first be changed to Transducer 2.
8.6.1.5
Transducer (2.1.5.)
Specifies the model of the Siemens transducer connected to the device.
Index
Single-point model
Dual-point model
Global
Transducer
Options
*No transducer (dual-point preset)
ST-25
ST-50
STH
XCT-8
*XPS-10 (single-point preset)
XCT-12
XPS-15
XRS-5
mA input
Related
• Current Input (2.6.) (Page 184)
• Blanking (2.2.6.) (Page 171)
• Reform echo (2.11.2.5.) (Page 223)
• TVT Shaper (2.11.4.) (Page 231)
• Number of short shots (2.1.11.) (Page 166)
• Number of long shots (2.1.12.) (Page 167)
• Short shot frequency (2.1.7.) (Page 165)
• Long shot frequency (2.1.8.) (Page 165)
• Long shot duration (2.1.10.) (Page 166)
• Short shot duration (2.1.9.) (Page 166)
• Short shot range (2.11.2.12.) (Page 226)