Siemens HydroRanger 200 HMI - Page 80

Commissioning
6.5 Quick Start Wizards
HydroRanger 200 HMI
78 Operating Instructions, 06/2018, A5E36281317-AC
PMD dimensions
The dimensions of the Primary Measuring Device (PMD).
Note
•
For each PMD excluding Exponential Devices, [see Primary measuring device (2.13.2.)
(Page 240), you must enter up to four dimensions.
•
In the wizard, you will be prompted for each dimension required for the PMD selected,
and the respective PMD dimension name will be displayed.
Index
Single-point model
Dual-point model
Global
Transducer and Dimension
Index values
for supported
PMDs
Dimension name (parameter menu reference)
Palmer-Bowlus
Flume width (2.13.5.1. OCM Dimension 1) (Page 246)
H-Flume
Flume height (2.13.5.1. OCM Dimension 1) (Page 246)
Rectangular Flume BS-3680/ISO 4359
Approach width B (2.13.5.1. OCM Dimension 1) (Page 246)
Throat width b (2.13.5.2. OCM Dimension 2) (Page 246)
Hump height P (2.13.5.3. OCM Dimension 3) (Page 246)
Throat Length L (2.13.5.4. OCM Dimension 4) (Page 246)
Velocity coefficient (read only)
(2.13.5.5. OCM Dimension 5) (Page 246)
Discharge coefficient (read only)
(2.13.5.6. OCM Dimension 6) (Page 246)
Thin Plate V-Notch Weir
Notch angle (2.13.5.1. OCM Dimension 1) (Page 246)
Discharge coefficient (read only)
(2.13.5.2. OCM Dimension 2) (Page 246)