General information for commissioning
1.2 BICO interconnection procedure in STARTER
Function Manual
28 Function Manual, 01/2011, 6SL3097-4AB10-0BP3
Graphical screen interface
When carrying out BICO interconnection via the graphical screen interface, proceed as
follows:
If for the setpoint speed, for example, you want to interconnect p parameter p1155[0] for
"speed setpoint 1" with r parameter r2060[1], proceed as follows:
Figure 1-6 Interconnection via graphical screen interface 1
1. In the project navigator under Drive_1 → Open loop/closed loop control, double-click the
selection Setpoint addition.
To Next Page
Loading...
