Drive functions
7.3 Function modules
Function Manual
Function Manual, 01/2011, 6SL3097-4AB10-0BP3
235
7.3.6.1 Mechanical system
Features
● Backlash compensation (p2583)
● Modulo offset (p2577)
Description
%DFNODVK
S
Figure 7-47 Backlash compensation
When mechanical force is transferred between a machine part and its drive, generally
backlash occurs. If the mechanical system was to be adjusted/designed so that there was
absolutely no play, this would result in high wear. Thus, backlash (play) can occur between
the machine component and the encoder. For axes with indirect position sensing,
mechanical backlash results in a falsification of the traversing distance, as, at direction
reversal, the axis travels either too far or not far enough corresponding to the absolute value
of the backlash.
Note
The backlash compensation is active, after
the axis has been referenced for incremental measuring systems
the axis has been adjusted for absolute measuring systems
In order to compensate the backlash, the determined backlash must be specified in p2583
with the correct polarity. At each direction of rotation reversal, the axis actual value is
corrected dependent on the actual traversing direction and displayed in r2667. This value is
taken into account in the position actual value using p2516 (position offset).
If a stationary axis is referenced by setting the reference point or an adjusted axis is
powered-up with an absolute encoder, then the setting of parameter p2604 (reference point
approach, starting direction) is relevant for switching-in the compensation value.
To Next Page
Loading...
Need help?
General
