Siemens SINAMICS S110 - Interconnecting Signals Using BICO Technology

Basic information about the drive system
10.4 BICO technology: Interconnecting signals
Function Manual
676 Function Manual, 01/2011, 6SL3097-4AB10-0BP3
10.4.3 Interconnecting signals using BICO technology
To interconnect two signals, a BICO input parameter (signal sink) must be assigned to the
required BICO output parameter (signal source).
The following information is required for connecting a binector/connector input to a
binector/connector output:
● Binectors: Parameter number, bit number, and drive object ID
● Connectors with no index: Parameter number and drive object ID
● Connectors with index: Parameter number, index, and drive object ID
● Data type (signal source for connector output parameter)
%2ELQHFWRURXWSXW
&2FRQQHFWRURXWSXW
6LJQDOVRXUFH
%,ELQHFWRULQSXW
&,FRQQHFWRULQSXW
6LJQDOVLQN
&2ZLWKRXWLQGH[
&2ZLWKLQGH[
U
,QGH[ >@
U
U
>@
>@
U
>@
U
%2
U
S[[[[\

%,
S[[[[\
>@
&,
S[[[[\

&,
Figure 10-8 Interconnecting signals using BICO technology
Note
A connector input (CI) cannot be interconnected with any connector output (CO, signal
source). The same applies to the binector input (BI) and binector output (BO).
For each CI and BI parameter, the parameter list shows under "data type" the information
on the data type of the parameter and the data type of the BICO parameter.
For CO parameters and BO parameters, only the data type of the BICO parameter is
shown.
Notation:
Data types BICO input: Data type parameter / Data type BICO parameter
Example: Unsigned32 / Integer16
Data types BICO output: Data type BICO parameter
Example: FloatingPoint32
The possible interconnections between the BICO input (signal sink) and the BICO output
(signal source) are listed in the following documents:
References: SINAMICS S110 List Manual
Section "Explanation of list of parameters", table "Possible combinations for BICO
interconnections".
The BICO parameter interconnection can be implemented in different command data sets
(CDS). The different interconnections are activated by switching data sets. Interconnections
across drive objects are also possible.