Basic information about the drive system
10.3 Working with the memory card
Function Manual
Function Manual, 01/2011, 6SL3097-4AB10-0BP3
673
10.3.4 Removing the memory card safely
CAUTION
The file system on the memory card may be destroyed if the card is removed without
requesting and confirming this action in advance via the "Safe removal" function. If this
happens, the memory card no longer works and has to be repaired.
If you want to remove the memory card from the device, proceed as follows:
● Set parameter p9400 = 2.
● Wait until the value of parameter p9400 changes to "3": The memory card can now be
removed safely.
● If the value of parameter p9400 changes to "100", the memory card cannot be removed
safely. Wait until the memory card is no longer being accessed and make a repeat
request for safe removal via p9400 = 2.
10.3.5 Integration
Overview of important parameters (see SINAMICS S110 List Manual)
● p0977: Save all parameters
● p0802: Data transfer with memory card as source/target
● p0803: Data transfer with device memory as source/target
● p0804: Start data transfer
– p0804 = 1 : Transfer from the memory card to non-volatile device memory
– p0804 = 2: Transfer from non-volatile device memory to the memory card
– If an error occurs during transfer of parameter data, this is also displayed in parameter
p0804 (p0804 = 1001, 1002, 1003, or 1100).
● p7827 Firmware update progress indicator
● p9400 Remove card safely
To Next Page
Loading...
