Function Manual
Function Manual, 01/2011, 6SL3097-4AB10-0BP3
45
Commissioning with PROFIBUS
3
3.1 Sequence of operations during commissioning
Once the basic requirements have been met, you may proceed as follows to commission the
drive:
Table 3- 1 Commissioning
Step Activity
1 Create project with STARTER.
2 Configure the drive unit in STARTER.
3 Save the project in STARTER.
4 Go online with the target device in STARTER.
5 Load the project to the target device.
6 The motor starts to run.
Note
If motors with a DRIVE-CLiQ interface are used, all motor and encoder data should be saved
in a non-volatile manner for spare part usage of the Sensor Module on the motor via p4692 =
1.
To Next Page
Loading...
