Siemens SINAMICS S110 - Safety Guidelines; STARTER Commissioning Tool

Commissioning with PROFIBUS
3.2 STARTER commissioning tool
Function Manual
46 Function Manual, 01/2011, 6SL3097-4AB10-0BP3
3.1.1 Safety guidelines
DANGER
A hazardous voltage will be present in all components for a further five minutes after the
system has been shutdown.
Note the information on the component!
CAUTION
A project with Safety Integrated must only be created online.
Note
Please observe the installation guidelines and safety instructions in the SINAMICS S110
Equipment Manual.
CAUTION
In STARTER, after the changeover of the axis type via p9302/p9502 and subsequent
POWER ON, the units that depend on the axis type are only updated after a project upload.
3.2 STARTER commissioning tool
Brief description
The STARTER commissioning tool is used to commission drive units from the SINAMICS
product family.
STARTER can be used for the following:
● Commissioning
● Testing (via the control panel)
● Drive optimization
● Diagnostics
System prerequisites
The system requirements for STARTER can be found in the "Readme" file in the STARTER
installation directory.