Siemens SINAMICS S110 - Internal Encoding of the Binector;Connector Output Parameters; Sample Interconnections

Basic information about the drive system
10.4 BICO technology: Interconnecting signals
Function Manual
Function Manual, 01/2011, 6SL3097-4AB10-0BP3
677
10.4.4 Internal encoding of the binector/connector output parameters
The internal codes are required for writing BICO input parameters via PROFIBUS, for
example.
ELQ ELQELQ
ELQ ELQELQ
KH[ದದ!)HVWHರರ
KH[ದದ!)HVWHರರ
()&KH[ದದ!&2>@
ELQ ELQELQ
3DUDPHWHUQXPEHU
([DPSOHVIRUVLJQDOVRXUFHV
,QGH[QXPEHU
'ULYH
REMHFW
'HYLFHHJ&8
RZQREMHFW
GHF GHFGHF


%LW      ಹಹಹ
Figure 10-9 Internal encoding of the binector/connector output parameters
10.4.5 Sample interconnections
Example: Interconnection of digital signals
Suppose you want to operate a drive via terminals DI 0 and DI 1 on the Control Unit using
jog 1 and jog 2.
,QWHUQDO
,QWHUQDO
-RJ
-RJ
-RJ
-RJ
%2ELQHFWRURXWSXW
6LJQDOVRXUFH
%,ELQHFWRULQSXW
6LJQDOVLQN
U
U
',;
',;
S&
S&
9
U
U
',;
',;
S&

S&

9
Figure 10-10 Interconnection of digital signals (example)