Basic information about the drive system
10.8 Licensing
Function Manual
Function Manual, 01/2011, 6SL3097-4AB10-0BP3
685
10.8 Licensing
Description
SINAMICS S110 requires that a license purchased specifically for this purpose is assigned
to the hardware if the Extended Functions of Safety Integrated are to be used. In doing this
you will receive a license key, which links the Extended Functions of Safety Integrated with
the hardware electronically. In order to assign the license to the hardware, you must have a
memory card (this also has to be purchased separately).
The license key is an electronic license stamp declaring that one or more software licenses
have been purchased.
Actual customer verification of the license for the software that is subject to license is called
a certificate of license.
Note
Refer to the order documentation (e.g. catalogs) for information on basic functions and
functions subject to license.
System response where license is insufficient for an option
An insufficient option license is indicated via the following alarm and LED on the Control
Unit:
● A13000 License not sufficient
● RDY LED flashes green/red at 0.5 Hz
NOTICE
The drive system can only be operated with an insufficient option license during
commissioning and servicing.
The drive requires a sufficient license in order for it to operate normally.
To Next Page
Loading...
