Commissioning preparations for PROFIBUS
2.3 Connection via serial interface
Function Manual
Function Manual, 01/2011, 6SL3097-4AB10-0BP3
41
3. The Control Unit's PPI address is pre-set to "3" in the factory.
4. You should also set the bus address to "3" during setup, or under "Properties" in the drive
unit's shortcut menu.
Figure 2-3 Setting the bus address
5. You must use a null modem cable to connect the PC (COM interface) to the Control Unit.
This interface must not be switched.
To Next Page
Loading...
