Siemens SINAMICS S110 - Page 574

Communication
9.2 Communication according to PROFIdrive
Function Manual
572 Function Manual, 01/2011, 6SL3097-4AB10-0BP3
E_DIGITAL (digital inputs)
See function diagram [2498].
Table 9- 31 Description of E_DIGITAL (digital inputs)
Bit Meaning Remarks Parameter
0 Digital input/output 8
(DI/DO = 8)
– DI/DO 8 on the Control Unit must be parameterized as an input
(p0728.8 = 0).
BO: p0722.8
1 Digital input/output 9
(DI/DO = 9)
– DI/DO 9 on the Control Unit must be parameterized as an input
(p0728.9 = 0).
BO: p0722.9
2 Digital input/output 10
(DI/DO = 10)
– DI/DO 10 on the Control Unit must be parameterized as an input
(p0728.10 = 0).
BO:
p0722.10
3 Digital input/output 11
(DI/DO = 11)
– DI/DO 11 on the Control Unit must be parameterized as an input
(p0728.11 = 0).
BO:
p0722.11
4...7 Reserved – – –
8 Digital input 0 (DI 0) – Digital input DI 0 on the Control Unit BO: r0722.0
9 Digital input 1 (DI 1) – Digital input DI 1 on the Control Unit BO: r0722.1
10 Digital input 2 (DI 2) – Digital input DI 2 on the Control Unit BO: r0722.2
11 Digital input 3 (DI 3) – Digital input DI 3 on the Control Unit BO: r0722.3
12...15 Reserved – – –
Note:
The bidirectional digital inputs/outputs (DI/DO) can be connected as either an input or an output (see also receive signal
A_DIGITAL).
MT_ZSW
Status word for the "central probe" function.
Table 9- 32 Description of MT_ZSW (status word for the "central probe" function)
Bit Meaning Remarks Parameter
0 Digital input probe 1 –
1 Digital input probe 2 –
2 Digital input probe 3 –
3 Digital input probe 4 –
4 Digital input probe 5 –
5 Digital input probe 6 –
Digital input display
6...7 Reserved – –
8 Sub-sampling probe 1 –
9 Sub-sampling probe 2 –
10 Sub-sampling probe 3 –
11 Sub-sampling probe 4 –
12 Sub-sampling probe 5 –
13 Sub-sampling probe 6 –
Not yet carried out.
14...15 Reserved – –
CO: r0688