Commissioning with PROFIBUS
3.6 Initial commissioning using servo AC DRIVE with BOP20 as an example
Function Manual
Function Manual, 01/2011, 6SL3097-4AB10-0BP3
63
Procedure Description Factory
setting
9.
Switching the drive on with the ON pushbutton
Binector output r0019.0 is set using this pushbutton.
* These parameters offer more setting options than the ones described here. For more possible settings, see the
SINAMICS S110 List Manual.
[CDS] Parameter depends on command data sets (CDS). Data set 0 is preset.
[DDS] Parameter depends on drive data sets (DDS). Data set 0 is preset.
BI binector input
BO binector output
CI connector input
CO connector output
To Next Page
Loading...
