Siemens SIREMOBIL Iso-C

110 Replacing boards and components
SIREMOBIL Iso-C SPR2-230.840.01.01.02 © Siemens, 2008
08.08 CS PS SP
Page 110 of 148
For internal use only
NOTE
With present MODULARIS system, the parameters for the
Litho program have to be set again according to the LITHOS-
TAR MODULARIS Service Instructions.
Storage of Dose on disk If dose-area product measurement device is present (Dia-
mentor), configure Yes. Otherwise configure No.
Dose on Hardcopy output If dose-area product measurement device is present (Dia-
mentor), configure Yes. Otherwise configure No.
x Perform IQ quick test.