Siemens SITRANS TSinsert - Remote Operation; Simatic Pdm; Overview SIMATIC PDM; Check SIMATIC PDM Version

Remote operation
B
B.1 SIMATIC PDM
B.1.1 Overview SIMATIC PDM
SIMATIC PDM (Process Device Manager) is a general-purpose, manufacturer-independent tool
for the con󹪝guration, parameter assignment, commissioning, diagnostics and maintenance of
intelligent 󹪝eld devices and 󹪝eld components. Follow-up installations and additional
information on SIMATIC PDM are available on the Internet at SIMATIC PDM (www.siemens.com/
simatic-pdm).
SIMATIC PDM monitors the process values, alarms and status signals of the device. It allows you
to display, compare, adjust, verify, and simulate process device data; also to set schedules for
calibration and maintenance.
For information on, for example, how to install and integrate devices, commission the software,
see Operating Manual 'Help for SIMATIC PDM'. The manual is delivered with SIMATIC PDM
software. Once the SIMATIC PDM is installed on your computer you 󹪝nd the manual under: Start
> All programs > Siemens Automation > SIMATIC > Documentation. Link at our website:
SIMATIC PDM instructions and manuals (https://support.industry.siemens.com/cs/ww/en/ps/
16983/man).
Note
Field device parameters
• For a list of parameters and additional information, consult section "Overview of parameters
and functions (Page 69)".
• The 󹪝eld device remains in measurement mode during the time you con󹪝gure the 󹪝eld
device.
B.1.2 Check SIMATIC PDM version
Check the support page of our website to make sure you have the latest version of SIMATIC PDM,
the most recent Service Pack (SP) and the most recent hot 󹪝x (HF). Go to:
Software downloads (
https://www.siemens.com/processinstrumentation/downloads).
In the Product tree, navigate: "Automation Technology > Process control systems > SIMATIC PCS
7 > System components > Plant Device Management > SIMATIC PDM".
SITRANS TS100/TS200/TS300/TS500/TSinsert/TSthermowell
Operating Instructions, 08/2020, A5E47810090-AA 191