Siemens SITRANS TSinsert - Assigning Parameters Using Remote Operation; Introduction; Quick Start Wizard

8.4 Assigning parameters using remote operation
8.4.1 Introduction
Introduction
This section describes the most important parameters and functions that are available
additionally over remote operation:
• "Quick Start" wizard
• Identi󹪝cation (TAG)
• Custom type
• Sensor calibration
• Transmitter sensor matching
• Assignment of dynamic variables
• Current output
8.4.2 "Quick Start" wizard
You use the "Quick start" wizard to con󹪝gure your device in 󹪝ve steps for the required application:
• Step 1: Identi󹪝cation
• Step 2: Sensor settings
• Step 3: Assignment of dynamic variables
• Step 4: Process parameters
• Step 5: Process alarms
• Step 6: Summary
The summary provides an overview of the "old" and "new" parameters.
To store the parameters in SIMATIC PDM and transfer them to the device, click the "Apply"
button.
Parameter assignment
8.4 Assigning parameters using remote operation
SITRANS TS100/TS200/TS300/TS500/TSinsert/TSthermowell
Operating Instructions, 08/2020, A5E47810090-AA 95