Siemens SITRANS TSinsert User Manual

8.3.16.1 Recovering the user PIN
Requirement
• You have received the PUK from Technical Support (Page 190) using the serial number of
your device.
• The "User PIN (Page 91)" parameter is enabled.
Procedure
1. In the parameter view, select the "PIN recovery" parameter.
2. Press the button.
The cursor and the "EDIT" symbol 󹪞ash.
3. Enter the digits of the PUK:
– Use the or button to change.
– Use the button to con󹪝rm.
– Use the button to delete.
The complete PUK is shown on the top line of the display.
4. When the PUK is complete, use the button to con󹪝rm.
Result
• If you have entered the correct PUK, the message "NEW PIN - 2457" appears.
The user PIN has been reset to the factory setting 2457.
• If the PUK was not correctly entered, the message "FAILD" appears.
Then repeat the described procedure.
Parameter assignment
8.3 Parameter assignment over device with display
SITRANS TS100/TS200/TS300/TS500/TSinsert/TSthermowell
90 Operating Instructions, 08/2020, A5E47810090-AA

Siemens SITRANS TSinsert Specifications

General

Brand	Siemens
Model	SITRANS TSinsert
Category	Temperature Controller
Language	English