Siemens SITRANS TSinsert User Manual

IP54
< 208㼻
IP54
Figure 4-1 Mounting angle of plastic head type BM0
CAUTION
Loss of IP protection
Do not unscrew the device housing from the mounted parts with NPT threaded connection.
NOTICE
Incorrect mounting
The device can be damaged, destroyed, or its functionality impaired through improper
mounting.
• Before installing, ensure there is no visible damage to the device.
• Make sure that process connectors are clean, and suitable gaskets and glands are used.
• Mount the device using suitable tools. Refer to the information in Technical data (Page 127)
for installation torque requirements.
• Avoid temperature or mechanical shocks during mounting.
• Avoid excessive force or damaging of the on-site mechanical connections.
• Do not deform or adapt the thermowells.
• The use of additive seal or sealant (not in scope of delivery) is recommended between
sensor and thermowell.
• Thermowells from carbon steel are protected against corrosion. Clean the thermowell
before mounting to avoid poisoning of the sensor and mounting problems.
Note
Loss of degree of protection
Damage to device if the enclosure is open or not properly closed. The degree of protection
speci󹪝ed on the nameplate is no longer guaranteed.
Installing/mounting
4.1 Basic safety notes
SITRANS TS100/TS200/TS300/TS500/TSinsert/TSthermowell
30 Operating Instructions, 08/2020, A5E47810090-AA

Siemens SITRANS TSinsert Specifications

General

Brand	Siemens
Model	SITRANS TSinsert
Category	Temperature Controller
Language	English