194
Kostal and Solar-Fabrik
Note
Each inverter must be accessible through the network individually.
It is thereby necessary to activate the network interface on each inverter (under the menu item “LAN”
select “Activate LAN”) and to connect the inverters to the network by means of a switch.
Detection via the Solar-Log™ WEB Interface
•
For detection on the Solar-Log™ , select the device class under the menu Configuration | Device | Definition |
Interface with the plus symbol and then select Kostal as the manufacturer. Confirm your selection with OK.
•
Save your selections and then start the Device Detection under Configuration | Device | Detection.
Detection from the Solar-Log 1200
•
When using the Solar-Log 1200, the detection can also be started from the display. Select the settings ►Start
► Initial Configuration ► Page 2 „Device“ ► Add and select the manufacturer Kostal from there. Save and
start the Device Detection.
Note Power Management (Inverter Settings):
The power reduction function is only available when the “Sensors” selection has been activated under
the -> Settings / Analog Inputs menu.
In order that reactive power control functions, the low-voltage guidelines have to be selected in the
country settings for the inverter (e.g. "DE-NSR" for the German low-voltage guidelines).
Caution:
The country settings can only be configured once during the initial installation. If the wrong country
is selected, it can be reset using the Kostal software tool "PARAKO." This tool can be obtained directly
from Kostal after registering.
To Next Page
Loading...