Solare Datensysteme Solar-Log - 3 IDM Heat Pumps; 3.1 IDM Heat Pumps

474
IDM Heat Pumps
3 IDMHeatPumps
3.1 IDMHeatPumps
Termination Addressing Interface
No Yes LAN
Overview
•
Integrated interface.
•
The IDM heat pump‘s IP address must be adapted.
•
Connected using network cable (patch cable) and Ethernet router or switch (when assigning a static IP ad-
dress).
• Another option is to connect directly to the main board of the navigator with a crossover cable.
•
Installation steps
• Assign a static IP address to the IDM heat pump or set the IDM heat pump to
DHCP.
• Connect the IDM heat pump to a switch (with a static IP address) or Ethernet router.
• Connect the Solar-Log™ to a switch (with a static IP address) or Ethernet router.
Assigning IP addresses
•
Configure the address according to the manufacturer‘s manual.
•
The DHCP range (IP address) for the heat pump has to be in the same subnet as the Solar-Log™.
•
Procedure: According to the manufacturer‘s manual.
Detection from the Solar-Log
™
•
For the detection on the Solar-Log
™
, select „IDM“ as the manufacturer in the Configuration | Devices | Defi-
nition
menu from the Network section. Confirm the selection with Save.
Detection from the Solar-Log 1200
•
When using the Solar-Log 1200, the detection can also be started from the display. Select „IDM“ as the manu-
facturer for the inverter detection from the „
network“ interface and start the detection.
Note
The IDM heat pump has to have Navigator 1.7.