Solare Datensysteme Solar-Log - 44 Hyundai; 44.1 Hyundai HPC-050 HT-E and HPC-100 HT-E

161
Hyundai
44 Hyundai
44.1 HyundaiHPC-050HT-EandHPC-100HT-E
Termination Addressing Interface
Yes Yes RS485
Overview
•
Integrated interface
•
Where to connect: RJ45 CN socket on the outside of the inverter
•
2-pin wiring
•
Communication address must be allocated
•
Installation steps
• Switch off the inverters and Solar-Log™
• Connect inverters to the Solar-Log™
• Connect the inverters to each other
• Allocate communication address
Connect inverters to the Solar-Log™
The wiring is done using a
•
ready-made data cable (optional extra; not supplied)
or
•
self-made cable connection with RS485 data cable and terminal block connector.
Caution
Risk of damage to the unit!
The Solar-Log™ also has an RJ45 socket, which must never be connected to the RJ45 socket on the
inverter.
► Only connect inverters via the RS485/422 Solar-Log™ interface(s).
Procedure
1. If you are making the cable yourself, connect the wires as shown in the following diagram:
Solar-Log™ terminal strip connector RJ45 inverter
Terminal PIN
► 1 ► 3
► 4 ► 6
2. Insert RJ45 plug into socket CN on the inverter.
3. If no further inverter is connected, terminate the inverter according to the instructions for the inverter
4. Insert the terminal block connector into the Solar-Log™ RS485 socket.