248
Reverberi
Procedure
1. Open the inverter as shown in the inverter's instructions.
2. Connect the other inverters to each other in the same way.
3. Terminate the last inverter.
4. Close inverters.
5. Allocate communication address
6. Recommendation: Continuous numbering from Solar-Log™, starting from 2 (not 1!). Last address at 247.
7. Setting: Using the inverter operating display
8. Procedure: Start according to the inverter's instructions
Note
A maximum of 31 inverters can be connected per RS485 bus.
To Next Page
Loading...