305
SMA
Assigning IP addresses
•
A static IP address has to be assigned to the inverter. This is set to automatic by default. Please refer to the
inverter's user manual for more information.
•
Please select an IP address with the same subnet as the Solar-Log™.
For example: The Solar-Log™ has the IP address 192.168.178.49.
The inverter in this case has to have a free IP address in the same range (from 192.168.178.2 to
192.168.178.254).
•
Procedure: Start according to the inverter's instructions
Detection via the Solar-Log™ WEB Interface
•
For detection on the Solar-Log™ , select the device class under the menu Configuration | Device | Definition |
Interface with the plus symbol and then select SMA as the manufacturer. Confirm your selection with OK.
•
Save your selections and then start the Device Detection under Configuration | Device | Detection.
Detection from the Solar-Log 1200
•
When using the Solar-Log 1200, the detection can also be started from the display. Select the settings ►Start
► Initial Configuration ► Page 2 „Device“ ► Add and select the manufacturer SMA from there. Save and start
the Device Detection. .
Note for feed-in management
The feed-in management functions are also available for the Bluetooth interface. Please note that the
necessary settings have to be configured with the manufacturer's software. Please refer to the inver-
ter's user manual for more information.
Note
Please refer to the instructions in the manufacturer's installation manual in regard to address types.
Note
Wiring with the bus.
Only one network connection is available per inverter with the integrated Speedwire interface.
A router or switch is required when using several inverters or when using the Ethernet (RS45) interface
on the Solar-Log™.
Note on the inverter detection.
For a successful inverter recognition requires the user password of the inverter in the
Solar-Log™ WEB menu, under Configuration | Feed-In Management | Plant passwords to enter.
► Important:
To call the point Plant passwords must be at the interface previously SMA selected.
To Next Page
Loading...