320
SolarMax
Note
The inverter's factory setting is communication address 255.
► On the inverter operating display set the communication address manually to 1 even if only one
inverter is connected to the Solar-Log™.
S series:
► When setting the communication address on the inverter display only the RS485 interface must be
activated (set at the factory), not the Ethernet interface that is also installed in the inverter.
Note for feed-in management
The inverter itself has to be configured with MaxTalk2 (SolarMax's software) and set to "Remote mode"
to be able to use reactive power management. Please refer to the inverter instructions for more infor-
mation on this topic.
To Next Page
Loading...