351
Sungrow
Connect the inverters to each other
•
Wiring via network cable (patch cable).
•
Where to connect: RJ45 socket on the outside of the inverter.
Procedure
1. Plug RJ45 plug into inverter 1 in socket „OUT“.
2. Plug the other end of the cable into the „IN“ socket of inverter 2.
3. Connect the other inverters to each other in the same way.
4. Terminate the last inverter in accordance with the inverter instructions.
5. Insert the terminal block connector into the Solar-Log™ RS485 socket.
Allocate communication address
•
Recommendation: Continuous numbering starting with 1.
•
Setting: Using the inverter operating display
•
Procedure: Start according to the inverter's instructions
To Next Page
Loading...