40
Advanced Energy
Connect the inverters to each other
•
Connect using the RS485 data cable with RJ45 plug;
Connection cables between the inverters are supplied with the inverters. Use these.
•
Where to connect: RJ45 socket on the outside of the inverter.
Procedure
1. Insert the RJ45 plug into the free RJ45 socket on the first inverter.
2. Insert the other end of the wire into any RJ45 socket on inverter 2.
3. Connect the other inverters to each other in the same way.
4. Terminate the last inverter.
Insert the connection plug into the free RJ45 socket.
Allocate communication address
1. Recommendation: Continuous numbering starting with 1.
2. Setting: Using the rotating switch on the inverter interface card.
3. Procedure: Start according to the inverter‘s instructions.
To Next Page
Loading...