450
QCells (hybrid system)
Detection via the Solar-Log™ WEB interface
•
For detection on the Solar-Log™, select the device class under the menu
Configuration | Device | Definition | Interface with the plus symbol and then select the device class (hybrid
system) and after that QCells as the manufacturer. Confirm your selection with
OK.
•
Save your selections and then start the Device Detection under Configuration | Device | Detection.
Detection from the Solar-Log 1200
•
When using the Solar-Log 1200, the detection can also be started from the display. Select the settings ► Start
► Initial Configuration ► Page 2 „Device“ ► Add and select the device class (hybrid system) and manufacturer
„QCells.“ Save and start the Device Detection.
Note
Only one QCells hybrid system can be connected to a Solar-Log™ device.
To Next Page
Loading...