452
SMA - Sunny Island Battery system
Detection via the Solar-Log™ WEB Interface
•
For detection on the Solar-Log™ , select the device class under the menu Configuration | Device | Definition
| Interface
with the plus symbol and then select „Battery“ as the Device class and then „SMA“ as the manu-
facturer. Confirm your selection with
OK.
•
Save your selections and then start the Device Detection under Configuration | Device | Detection.
Detection from the Solar-Log 1200
•
When using the Solar-Log 1200, the detection can also be started from the display. Select the settings ►Start
► Initial Configuration ► Page 2 „Device“ ► Add and select Battery and then „SMA: Sunny Island“. Save and
start the Device Detection.
Note
Only one battery system can be connected to a Solar-Log™ device.
Note
Sunny Island battery systems can be connected in a group up to 3 Sunny Island (cluster) in this group,
a Sunny Island is the master, while the others are the slaves. In such cases, only the master of this
cluster has to be recognized by the Solar-Log? via Ethernet.
Note
Each inverter has to be individually reachable via the network.
To do this, activate the network interface at each inverter via the SMA SUNNY EXPLORER and connect
the inverters into the network with a network switch.
Procedure:
► Set the „TCP Server“ to „On“ in the SMA SUNNY EXPLORER; Port=502.
To Next Page
Loading...