48
AEG
Connect the inverters to each other
•
Connect using a network cable (patch cable).
•
Where to connect: 2 RJ45 sockets on the right on the side cover.
Procedure
1. Unscrew the side cover as shown in the inverter's instructions.
2. Insert the RJ45 plug into any RJ45 socket on inverter 1.
3. Insert the other end of the wire into any RJ45 socket on inverter 2.
4. Connect the other inverters to each other in the same way.
5. Terminate the last inverter.
Insert the connection plug into the free RJ45 socket.
6. Screw the inverter cover on again.
To Next Page
Loading...