Solare Datensysteme Solar-Log - Page 497

497
Allnet Network Power Socket
ConnectingtheAllnetnetworkpowersockettotheSolar-Log™
The Allnet socket has to be defined with the device detection function to connect to the Solar-Log™. From the WEB
interface of the Solar-Log™ go to Configuration | Devices | Definition and select the device class „Switch“ with the
blue plus symbol and then Allnet as the manufacturer followed by the type and number of devices. Confirm the
selection with OK and start the detection from the Configuration | Devices | Detection menu. Let the detection
process run completely. After that, select the corresponding devices from the Configuration | Devices | Configura-
tion menu, enter the IP address and perform the rest of the setup. Click on save once everything is finished.
The last step is configuring the Smart Energy Logics. Refer to the Solar-Log ™ Smart Energy Manual for more infor-
matin. It is available from our website (https://www.solar-log.com/en/support/downloads).