63
Aten
Connect the inverters to each other
•
Connect using a 2 wire, shielded data cable.
•
Where to connect: RJ14 sockets.
Procedure
1. Open the inverter as shown in the inverter's instructions.
2. Insert the self-made cable with the RJ14 plug into any RJ14 socket on inverter 1.
3. Insert the RJ11 cable into the 2nd RJ11 socket on inverter 1 and into any RJ11 socket on inverter 2.
4. Connect the other inverters to each other in the same way.
5. Close inverters.
6. Insert the terminal block connector into the Solar-Log™ RS485 socket.
To Next Page
Loading...