65
Benning
Detection via the Solar-Log™ WEB Interface
•
For detection on the Solar-Log™ , select the device class under the menu Configuration | Device | Definition |
Interface with the plus symbol and then select Benning as the manufacturer. Confirm your selection with OK.
•
Save your selections and then start the Device Detection under Configuration | Device | Detection.
Detection from the Solar-Log 1200
•
When using the Solar-Log 1200, the detection can also be started from the display. Select the settings ►Start
► Initial Configuration ► Page 2 „Device“ ► Add and select the manufacturer Benning from there. Save and
start the Device Detection.
Note for feed-in management
Supported by Solar-Log starting with inverter firmware version 19.
Note
Using the inverter's web interface, select "External control via network interface" under “Settings ►
Installation ► Grid Company Settings ► Power Reduction," and under “cos(phi) Settings.”
To Next Page