Sonifex S2 - Page 132

To Next Page

To Previous Page

120

S2 User Handbook

Presets, P5 (left) and P4 (right), set the peak digits through the conditioning circuits to

the analogue to digital converter. This is preset on nal test and should not require

further adjustment.

Preset P8 sets the gain through the limiter that feeds the analogue to digital converters.

Preset P9 sets the threshold. Presets P6 & P7 are for altering the audio waveform symmetry

(i.e. distortion) through the limiting stage. They are all factory set on nal test and should

not be adjusted further.

Gain can be altered using P4 and P5 on board versions S2-OP-04 and above, as P8 is no

longer tted on these boards.

Button Mode Settings

To make the S2 modules as exible as possible, every button on each channel can be set

to a number of dierent modes. These will aid in the use of the mixer and allow for extra

functionality. To make use of these modes, you must enter a setup mode which is exactly

the same for every module. It is only necessary to perform this procedure once.

To enter the setup mode, hold down the PGM and AUD buttons together for 5 seconds.

After which all the buttons will start a recurring ashing sequence, at this point it is ok to

release the PGM and AUD buttons. This sequence indicates the mode which each button is

currently set to. One ash equals mode one, two ashes equals mode two etc. To change the

mode for a particular button simply press it once and watch the number of ashes increase.

Once the maximum mode number has been reached it will simply wrap around to mode

one and continue as before. To exit this setup procedure press and hold both the PGM and

AUD buttons as before for 2 seconds and the module will start operating

as normal.

Each button and their corresponding modes are listed below.

PGM

Mode 1 : Normal. PGM can be selected as the meter feeder as normal.

Mode 2 : Always on. PGM is permanently selected as the meter feed.

Mode 3 : Always o. PGM can never be selected as the meter feed.

AUD

Mode 1 : Normal. AUD can be selected as the meter feeder as normal.

Mode 2 : Always on. AUD is permanently selected as the meter feed.

S2ODAF/S2ODA DIGITAL OUTPUT AUD CHANNEL

WITH & WITHOUT MASTER FADER VERSION 2

S2ODAF/S2ODA DIGITAL OUTPUT

AUD CHANNEL WITH & WITHOUT

MASTER FADER VERSION 2