S2 User Handbook
131
S2OMS STUDIO MONITOR CHANNEL
19
S2OMS STUDIO MONITOR CHANNEL
Global Talkback Enable
Jumper J1 placed over pins 1 & 2 enables global talkback. This is a system whereby all
programme presenters, guests etc. can talk to each other from their individual microphones
via the monitoring system. When enabled, the system becomes active when the control
room and studio mutes are inactive i.e. no Mic channels with mic live muting are active. The
monitored source on each person’s headphones will dim by –12dB and they will be able
to talk and hear each other at a normal level. When a microphone channel fader is raised,
triggering a mute, the system will drop back into normal monitoring. The default setting for
J1 is disabled (not tted).
Studio Loudspeaker Talkback Enable
Jumper J2 placed over pins 1 & 2 enables talkback to the studio monitor loudspeakers. This
will allow talkback, activated by pressing the Studio T/B button, to replace the monitored
source on the loudspeaker monitors. If the monitors are already muted then talkback will
be muted too. Talkback will also appear on the studio headphones as a replacement to the
monitored source. The default setting for J2 is enabled.
Studio Loudspeaker Talkback Dim Enable
Jumper J3 placed across pins 1 & 2 enables talkback dimming of the studio monitor
loudspeakers. With J2 and J3 enabled, incoming talkback will dim the monitored source by
–12dB and talkback will be heard at normal level. The default setting for J3 is enabled.
Studio Headphones Talkback Dim Enable
Jumper J4 placed across pins 1 & 2 enables talkback dimming of the studio monitor
headphones. With J4 enabled, incloming talkback will dim the headphone source by –12dB
and talkback will be heard at normal level. The default setting for J4 is disabled (not tted).
Presets
There are no presets to tamper with on the studio monitor channel.
Button Mode Settings
To make the S2 modules as exible as possible, every button on each channel can be set
to a number of dierent modes. These will aid in the use of the mixer and allow for extra
functionality. To make use of these modes, you must enter a setup mode which is exactly
the same for every module. It is only necessary to perform this procedure once.
To enter the setup mode, hold down the PGM and AUD buttons together for 5 seconds.
After which all the buttons will start a recurring ashing sequence, at this point it is ok to
release the PGM and AUD buttons. This sequence indicates the mode which each button is
currently set to. One ash equals mode one, two ashes equals mode two etc. To change the
mode for a particular button simply press it once and watch the number of ashes increase.
Once the maximum mode number has been reached it will simply wrap around to mode
To Next Page
Loading...