74
S2 User Handbook
Source Remotes
The remote outputs for the six sources can be used for a start and stop function wired to
other studio equipment such as CDs or MDs. The default setting for J3 is none (not tted),
which produces a momentary remote contact. If your equipment requires a latching contact
for remote start then a jumper should be placed over pins 1 & 2 of J3. The remote stops are
always momentary. It is not possible to congure a latching remote start output when the
continuous momentary start option has been selected.
Timer Auto Start
The dual timer in the meterbridge can be set to start automatically from a fader open/
channel On signal. Jumper J4 determines which timer is set to auto-start. A jumper over pins
1 & 2 will start Timer 1, shifting the jumper to pins 2 & 3 will start Timer 2. The default setting
of J4 is none (not tted).
Presets
Two presets are available for adjustment of the input gain, left and right, for all six line
inputs. Presets, P1 (left), P2 (right) provide 16dB of gain adjustment, allowing an input
range of +6dB to –10dB referenced to 0dB output. The presets should be adjusted to give
0dB output for the chosen source, and will cater for professional equipment with nominal
output levels up to +4dB and non-professional equipment with nominal output levels down
to –10dBV. The levels are preset for 0dB input when shipped.
A third preset, P5, sets the VCA fader gain to 0dB when the fader is fully open. This is preset
on nal test and should not require further adjustment, unless it has been found necessary
to replace the fader or other VCA components.
Presets P3 & P4 are for altering the audio waveform symmetry (i.e. distortion). They are
factory set on nal test and should not be adjusted further.
Button Mode Settings
To make the S2 modules as exible as possible, every button on each channel can be set
to a number of dierent modes. These will aid in the use of the mixer and allow for extra
functionality. To make use of these modes, you must enter a setup mode which is exactly
the same for every module. It is only necessary to perform this procedure once.
To enter the setup mode, hold down the PGM and AUD buttons together for 5 seconds.
After which all the buttons will start a recurring ashing sequence, at this point it is ok to
release the PGM and AUD buttons. This sequence indicates the mode which each button is
currently set to. One ash equals mode one, two ashes equals mode two etc. To change the
mode for a particular button simply press it once and watch the number of ashes increase.
Once the maximum mode number has been reached it will simply wrap around to mode
one and continue as before. To exit this setup procedure press and hold both the PGM and
AUD buttons as before for 2 seconds and the module will start operating
as normal.
S2-C6SS 6 WAY STEREO LINE SOURCE SELECT CHANNEL WITH EQ
S2-C6SS 6 WAY STEREO LINE SOURCE
SELECT CHANNEL WITH EQ
10
To Next Page
Loading...