82
S2 User Handbook
AUD buttons as before for 2 seconds and the module will start operating
as normal.
Each button and their corresponding modes are listed below.
PGM
Mode 1 : Normal. The program bus can be selected as normal.
Mode 2 : Always on. The program bus is permanently selected.
Mode 3 : Always o. The program bus is permanently deselected.
AUD
Mode 1 : Normal. The audition bus can be selected as normal.
Mode 2 : Always on. The audition bus is permanently selected.
Mode 3 : Always o. The audition bus is permanently deselected.
EQ
Mode 1 : Normal. Equalization can be enabled or disabled as normal.
Mode 2 : Always enabled. Equalization controls are permanently enabled.
Mode 3 : Always disabled. Equalization controls are permanently disabled.
Cue/PFL & T/B
Mode 1 : Normal. Cue/PFL is selected as normal, with both a momentary or
latched operation.
Mode 2 : Latched. Cue/PFL is selected as normal, but will only work with a
latched operation.
Mode 3 : Momentary. Cue/PFL is selected as normal, but will only work with a
momentary operation.
ON
Mode 1 : Normal.
Mode2 : The LEDs in the ON button are controlled via the general purpose input, if
congured to do so. If the remote input is not active, then the ON button will be Red. If the
remote input is active then the ON button will be green. This is designed to show a visual
indication of the state of a TBU connected to the channel.
S2CT TELCO CHANNEL WITH EQ
S2CT TELCO CHANNEL WITH EQ
11
To Next Page
Loading...