Chapter 11 DME Operations
587
DME Special Effect Operations
Notes
The Total Ambient parameter is not supported on the MVE-8000A.
• When Preset is selected
a) Setting is available when nonlinear effect page turn, roll, cylinder, or sphere is selected.
b) You can make the Lighting effect more effective by adjusting [Total Ambient] to lower the
brightness of the entire image. This setting is used both by this effect and by the
Spotlighting effect.
Notes
The Total Ambient parameter is not supported on the MVE-8000A.
The three regions for which the light intensity can be set
Setting the bar shape of the highlight area
When you select [Bar] or [Preset] in step 3 of “Applying the Lighting effect”
(page 586), use the following procedure to set the shape of the bar.
1
Turn [Light Modify] on.
2
Adjust the following parameters.
Knob Parameter Adjustment Setting values
1 Light Intensity of light in highlight area 0.00 to 100.00
2 Ambient Intensity of light in ambient area 0.00 to 100.00
3 Shade Intensity of light in shade area
0.00 to 100.00
a)
5 Total Ambient Brightness of whole image
0.00 to 100.00
b)
Highlight area
Ambient area
Shade area
Knob Parameter Adjustment Setting values
1 X X-value of bar center point
–8.00 to +8.00
a) b)
–24.00 to +24.00
c)
–32.00 to +32.00
d)
To Next Page
Loading...
