Stryker Neptune 2 - Page 123

4. Disconnect nylon tubing from both ends of injector pump assembly (P/N 0702-001-
380) (AJ).
5. Using a 3/8” socket, loosen and remove the two hex nuts (P/N 0015-004-000) (AL) and
two flat washers (P/N 0011-512-000) (AK).
6. Remove the injector pump assembly (P/N 0702-001-380) (AJ) from the oscillating
piston pump mount (P/N 0702-001-382) (B) and set aside.
4-16