4. Once the technician menu is displayed, push the button next to the arrow icon
(on the left side) to highlight the DOCKING option. Then press the button next
to the OK icon to select the docking menu. (see figure 4)
ESC
OK
SYSTEM INFO
SOFTWARE REVS
DOCKING
LEVEL SENSOR
VACUUM
TECHNICIAN MENU
DOCKING
Figure 4: Select DOCKING Option
5. Next, push the button next to the arrow icon (on the left side) to highlight the
CONTROL option. Then press the button next to the OK icon to select the
docking menu. (see figure 5)
ESC
OK
ODOMETER
DOCKING
CONTROL
Figure 5: Select the DOCKING Option
6-12
To Next Page
Loading...
Need help?
General
