OnAir 2000M2 Digital Mixing Console
13-2 SW Update SW V 4.0 Date printed: 12.11.03
If your console should be equipped with an early Power Supply PCB
1.942.105.00, the smoothing capacitors C11 and C16 (22'000 µF) must be
modified to 33'000 µF (order no. 59.29.0323). Otherwise, after powering
the console off and on again, a warning message “Flash Verification –
Console Configuration corrupted!” or “Flash Verification – Current
Console State corrupted!” could be displayed. In this case, normally the
console can be operated as usual, without restrictions, but configuration
changes might get lost from time to time.
Please make sure that the console data are backed-up prior to any modifi-
cation as the internal data structure is different. Note the current customer
code setting (refer to chapter 12.2.12).
To Next Page
Loading...
Need help?
General
