On-Air 2000M2 Digital Mixing Console
Date printed: 12.11.03 SW V 4.02 New Features 3
In other words:
• For the 1
st
setting, both signaling outputs are active whenever any audio
signal is routed either to the program or the record output (or both).
• For the 2
nd
setting, only the PGM OUT signaling output is active while an
audio signal is routed to the program output. An audio signal routed to the
record output has no effect.
• For the 3
rd
setting, only the REC OUT signaling output is active while an
audio signal is routed to the record output. An audio signal routed to the
program output has no effect.
• For the 4
th
(new) setting, only the PGM OUT signaling output is active
while an audio signal is routed to the program output, and only the REC
OUT signaling output is active while an audio signal is routed to the rec-
ord output. If audio signals are routed to both the program and the record
outputs, both the PGM OUT and REC OUT signaling outputs are active.
Basic information on this subject to be found in chapter 12.2.2 (Operating
Instructions)
4 Additional Customer Codes
Code 0x00000800: Used to disable dimming of the CR monitor speakers during talkback from
the studio to the control room.
Code 0x00001000: Used to disable dimming of the studio monitor speakers during talkback
from the control room to the studio.
Code 0x00002000: Used to swap the functions of the PFL and the OFF keys next to the faders,
regardless whether they are used for the standard PFL and OFF functions,
or whether other functions are configured for any of these keys.
Basic information on this subject to be found in chapter 9 (Operating In-
structions)
Code 0x00004000: If this code is active, whenever a channel is activated by moving its fader
up from its lower stop while it is switched ON (or the other way round, by
switching the channel ON while its fader is positioned above the lower
stop), this channel’s Channel Control page pops up automatically and al-
lows for immediate changes of the channel settings. This Channel Control
page remains displayed until another channel is activated, or until another
page is selected using one of the five buttons next to the clock dial.
Code 0x00008000: If this code is active, the status of the channel ON/OFF switch of channels
currently not routed to the console surface will be saved in the flash mem-
ory when powering the console off. At power on, the ON or OFF status of
these channels will automatically be re-established.
If this code is inactive, the channels not routed to the console surface will
always be set to OFF at power on.
Basic information on Customer Code to be found in chapter 12.2.12 (Op-
erating Instructions)
To Next Page
Loading...
Need help?
General
