OnAir 2000M2 Digital Mixing Console
Date printed: 12.11.03 SW V4.0 Service Terminal 5-5
5.4 Service Terminal Commands
Command Syntax Impl.
User
mode
P: Processing
H: Header of next line (Level)
Debug user
mode
ServIf:\>deb[ug] yes Service
P: enter extended (Debug) User Mode
H: ServIf:\debug>
Back to the
next higher
level
ServIf:\debug>.. yes
Service or
Debug
P: return to Service User Mode
H: ServIf:\>
Display help
ServIf:\>h[elp]
(possible in any level)
or e.g. ServIf:\>help init
yes Service
P: Display and explain commands of Service mode
H: same (because the command is finished)
ServIf:\debug>h[elp] or
ServIf:\>help debug
yes Debug
P: Display and explain commands of Service and Debug mode
(all commands)
H: same
Default
initialisation
ServIf:\>init
ServIf:\debug>init
no
Service or
Debug
P: Reset Console Configuration and Current Console Status to
Factory Pre-set.
Send following messages to Channel Controller:
ResetChannel; ResetChannelInput; ResetAuxSend;
ResetInsert; ResetMonitor; ResetTelHybrid; HoldReset
H: same
Examine IFX
workspace
ServIf:\>ifxws
ServIf:\debug>ifxws
yes
Service or
Debug
P: Call ifx_gwksize(&wksize, &actsize, &errcount) and display
IFX workspace size, actual workspace in use and number of
workspace Tau small
H: same
Fader
calibration
ServIf:\>cal 1/2/3/4/all
ServIf:\debug>cal 1/2/3/4/all
yes
Service or
Debug
P: Send a Fader Calibration message to the Surface Controller
H: same
Reboot
ServIf:\>reboot
ServIf:\debug>reboot
yes
Service or
Debug
P: Sends the Reboot message to Diagnostics and Error
Handling task to reboot the console from flash
H: same
Init PGMasks
ServIf:\>pgminit
ServIf:\debug>pgminit
yes
Service or
Debug
P: Call fnInitMasks (UNCONDITIONAL)
H: same
Start SW
update
ServIf:\>startdownload
ServIf:\debug>startdownload
yes
Service,
Debug or
Message
P: Poll PC-Card and SMC1 for ‘incoming’ data and send
SwUpdateState message to Surface Controller.
Clear PGMASKs-, Data-, Snapshot and Master Sections.
Passes Data from PC-Card or SMC1 to the code loader until it
indicates ‘completed’ or no more data are received, send
SwUpdateState to Surface Controller and indicate the status on
ServiceIf.
If download completes successfully
{Calculate the checksum over the complete Master Section
and write it into its last word. Reboot the Console by SW
RESET}
H: same
Cancel SW
update
ServIf:\>stopdownload
ServIf:\debug>stopdownload
yes
Service,
Debug or
Message
P: Stops polling or receiving data from PC-Card or SMC1
H: same
Power down
ServIf:\>down
ServIf:\debug>down
yes
Service or
Debug
P: Simulates a powerdown.
Puts a PowerFail telegram in the input queue of
DiagnosticsandErrorHandling task.
H: same
Customer code
ServIf:\>ccode
0x00...0xFFFFFFFF
ServIf:\debug>ccode
yes
Service,
Debug or
Message
P: Write the Customer Code into prevVersion of CUC, and ask
the user to reboot the console.
H: same