OnAir 2000M2 Digital Mixing Console
5-14 Master Functions SW V 4.0 Date printed: 12.11.03
When powering the console off and on again, the channels in the
background are always set to OFF, to prevent audio from being played out
unintentionally.
Auto Takeover When a new channel routing is loaded or when a user logs in, the input
module-to-fader strip assignment is modified. In this moment, the audio
level of an input signal may not correspond to the physical position of the
new fader. As the OnAir 2000M2 does not feature motorized faders, the
Auto Takeover symbol is displayed in the corresponding channel section
of the fader screen. By moving the fader knob up or down in the indicated
direction, the audio level is caught, and control is gained over the signal
again.
To Next Page
Loading...
Need help?
General
