GTS Technical Manual
9. April 2021 Edition: V1.00/2021 3-2
Copyright © 2020, Diversey
03.1 TASKI - general_V1.40.fm
3.1.3 Consumable supplies
If you have to remove cable ties then position the new ones at the
original place.
If you have to remove self locking nuts, you should replace them by
new ones.
If you have to remove retaining washers, observe the condition and
replaced them with new ones, if they do not fit tight anymore.
Use adhesive locking when ever mentioned in the Technical Manual or
TASKI spares.
Use ball bearing grease when ever mentioned in the Technical Manuel
and TASKI spares.
3.1.4 Direction description
On the „RH“ always means on the right hand side of the machine in
working direction (when you are standing behind the machine).
On the „LH“ always means on the left hand side of the machine in
working direction (when you are standing behind the machine).
3.1.5 Power source
Depending on the work it might be required to remove the power
source (mains/batteries) from the machine.
The in here mentioned sequences (mechanical and electrical) are
based on the assumption that the power source (mains/batteries)
were removed from the machine before.
To Next Page
Loading...
Need help?
General