Taski AERO 3500 micro - Removing of Brush Motor for Offset

GTS Technical Manual
9. April 2021 Edition: V1.00/2021 5-38
Copyright © 2020, Diversey
05.30.25 tool lowering unit - brush motor offset - 3500µicro_V1.00.fm
5.6 Tool lowering unit
5.6.5 Removing of brush motor for offset
Picture 55: Brush motor for offset
• Remove the tool.
• Lower the brush drive for easier access.
• Disconnect the brush motor wires from the connection block
(4082740) which is mounted on the tool lowering support
(4134076).
• Remove the screw (4006900) and countersunk washer
(4134329) from the brush motor (4134077).
• Remove the coupling disc (4134078) by pulling it of the brush
motor axle.
Picture 56: Brush motor coupling disc
• Remove the four screws (4006430) and washer (4007470) from
the brush support plate (4134080).
• Remove the brush motor offset (4134077).