GTS Technical Manual
9. April 2021 Edition: V1.00/2021 6-35
Copyright © 2020, Diversey
ST.08.16 error codes overview - 2100_4000_5000_3500µicro_V1.40.fm
111 Magnetic valve Short circuit has been detected.
Check magnetic valve, wires and connections.
Pump and magnetic
valve are turned OFF
E0111
113 Invalid machine type An invalid machine type has been detected when machine
switched ON.
Check the machine code wire and connection.
Aggregates are
turned OFF and ma-
chine drives on re-
duced speed
E0113
121 Pump 1 Short circuit has been detected.
Check pump 1, wires and connections.
Pump and magnetic
valve are turned OFF
E0121
122 Pump 2 Short circuit has been detected.
Check pump 2, wires and connections.
Pump and magnetic
valve are turned OFF
E0122
200 Communication Communication between power electronics and dash-
board has failed. The machine still works with the present
adjustment until turned OFF.
Check the TASKI-Bus, wires and connections.
Offline
300 Signal throttle Out of range signal (<0.5 or >4.5VDC) has been detect-
ed. The machine does not drive and turns OFF the aggre-
gates.
Check throttle sensor, wires and connections.
No drive movement E0300
301 Signal steer angle Out of range signal (<0.5 or >4.5VDC) has been detect-
ed. The machine runs on reduced speed and aggregates
work normally.
Check steer angle sensor, wires and connections.
Machine drives on
reduced speed
E0301
302 Signal brush lowering Out of range signal (<0.5 or >4.5VDC) has been detect-
ed. The brush unit goes up and the brush motors are
turned OFF.
Check brush lowering sensor (implemented in linear
drive), wires and connections.
Brush unit goes up
and brush motor is
turned OFF
E0302
Error codes Function Control Machine status Display
informa-
tion
Table 4: Error codes overview
To Next Page
Loading...
Need help?
General